Skip to main content

columbusfurnace.repair

Yes — if you have no heat at night, Columbus, OH, first check the thermostat, the furnace power switch and breaker, and the filter. If those are fine and the furnace still has no heat, call our 24/7 emergency line at (380) 273-8167. If you smell gas or the carbon monoxide alarm sounds, leave the home and call 911.

Is the thermostat set right?

Start here, because this is the most common — and easiest — cause. Make sure the thermostat is set to Heat, not Cool or Off, and that the temperature is set a few degrees above the current room temperature. Set the fan to Auto, not On, so the blower does not keep running when the furnace is not heating. If the display is blank, try fresh batteries if your model uses them, and check that the thermostat is not in a hold, schedule or away mode that is keeping the heat off.

This check matters most at the first cold snap of the season, especially the first time turning your furnace on in the fall in Columbus. If the display is blank or the system does nothing at all, see our guide to a furnace not turning on before you move on to the next checks.

Night tip: Before you call, note the thermostat setting, whether the furnace power switch is on, and whether the furnace shows a blinking light. That short list helps the technician narrow down the fault faster when you call.

No heat at night, Columbus, OH — thermostat check in Pickerington, OH

Is the furnace power switch / breaker off?

Next, look for the furnace power switch. It usually looks like an ordinary light switch on the wall near the furnace, sometimes with a red cover, and it can be bumped off by accident. Make sure it is in the On position. Then check your breaker panel for a tripped furnace breaker. If one has tripped, reset it once. If it trips again straight away, leave it off and call for help — a breaker that keeps tripping is a sign of a fault that needs a technician.

If the whole home has no power, the problem is the power supply, not the furnace. Check whether neighbours have power too, and check for an outage with AEP Ohio. If only the furnace is out, the switch and breaker checks above are the right place to start when you have no heat at night, Columbus, OH.

Furnace emergency power switch check in Powell, OH

Is the filter clogged?

A clogged filter restricts airflow, so the furnace can overheat and shut itself off, or run without warming the home properly. Pull the filter out and hold it up to the light. If you can barely see through it, or it looks grey and matted with dust, replace it with the same size and type. Make sure it is fitted the right way round, following the airflow arrow printed on the frame.

After fitting a clean filter, turn the heat back on and give the furnace a few minutes to run. If the furnace starts, warms up and stays on, the filter was likely the problem. If it still shuts off soon after starting, move on to the next check and do not keep restarting it over and over.

Is the flame sensor or pilot the problem?

If the furnace starts, then stops again within seconds, a dirty flame sensor is a common cause. The sensor is a small rod that proves the flame is lit; when it is coated in soot, the furnace shuts the gas off as a safety measure. This is a job for a technician — do not take gas parts apart yourself at night. Ask about flame sensor cleaning and replacement when you call, and mention exactly how long the furnace runs before it stops.

The same short-cycling pattern is covered in our guide to a furnace keeps shutting off. If the blower runs but the air coming from the vents feels cold, see our guide to a furnace blowing cold air — the cause is often different from a furnace that will not start at all.

Furnace flame sensor at night in Columbus, OH

When should you call for emergency help for no heat at night, Columbus, OH?

Call for 24/7 emergency furnace repair in Columbus, OH at (380) 273-8167 if you have worked through the thermostat, power and filter checks above and the furnace still has no heat, or if the temperature in the home keeps dropping. Do not wait until morning if the furnace will not stay on, if it keeps tripping the breaker, or if you hear banging, grinding or other unusual noise — see our guide to a furnace making noise for what those sounds can mean, and call for help.

Our technicians service 7 furnace brands across Columbus and 13 suburbs. The average Columbus repair is $304, according to Angi, with a typical range of $123 to $505, and the price is quoted before work begins. For more detail, see the furnace repair cost in Columbus, OH page and our wider furnace repair cost guide. If the same fault keeps coming back, ask whether furnace replacement in Columbus, OH makes more sense than another repair — and, if so, about furnace installation in Columbus, OH and what size furnace you need in Columbus, OH.

HVAC technician on a night service call in Grove City, OH

How do you stay warm and safe while waiting?

While you wait for help with no heat at night, Columbus, OH, close off rooms you are not using, close the curtains, and gather in one room with extra layers and blankets. Keep doors to unused rooms shut so the warmth you have stays where you are. Do not use the oven, a grill or an unvented heater to heat the home, and do not leave a space heater running unattended. If the home is getting very cold and you have somewhere warm to go, go there rather than waiting it out in a cold house. For the full method, see our guide to staying warm while waiting for furnace repair in Columbus.

Emergency furnace repair at night in Columbus, OH

What if you smell gas or the CO alarm goes off?

If you smell gas, leave the home right away. Do not flip light switches or other switches, and do not use a phone inside the home. Once you are outside, call 911 and Columbia Gas of Ohio. Do not go back inside until you are told it is safe. The same rule applies if your carbon monoxide alarm goes off: leave the home, get fresh air, and call 911 from outside.

Keep carbon monoxide detectors on every level of the home, and check them regularly. For more on detectors, alarms and what to do, see our guide to carbon monoxide furnace safety in Columbus, OH. Gas and carbon monoxide are the two situations where you should never wait to see if the problem goes away.

Most no-heat calls at night, Columbus, OH, come down to the thermostat, the power switch or breaker, or a clogged filter — the three checks at the top of this guide. If none of them brings the heat back, call (380) 273-8167 for 24/7 help. A regular furnace tune-up in Columbus, OH can also catch worn parts before they fail on a cold night.

Why is there no heat at night, Columbus, OH?

The most common causes of no heat at night, Columbus, OH, are the thermostat being set wrong, the furnace power switch or breaker being off, and a clogged filter. Check those three first. If the furnace starts and then stops within seconds, a dirty flame sensor is another common cause.

Should I call for emergency furnace repair at night, or wait until morning?

Call at night if the furnace still has no heat after the thermostat, power and filter checks, or if the temperature in the home keeps dropping. Our 24/7 emergency line is (380) 273-8167.

How much does furnace repair cost in Columbus, OH?

The average Columbus repair is $304, according to Angi, with a typical range of $123 to $505. The price is quoted before work begins.

What should I do if I smell gas at night?

Leave the home right away. Do not flip switches or use a phone inside. Once outside, call 911 and Columbia Gas of Ohio, and do not go back inside until you are told it is safe.

2 Responses

Leave a Reply

Your email address will not be published. Required fields are marked *

Call 24/7: (380) 273-8167